 |
1. Plastic reel can be adjusted to fit 120 |
 |
2. Or 135. |
 |
3. From this steps on, all operation must be done in total darkness or inside changing bag. Lead the film end to the entrance reaching a secure position. |
 |
4. Release the left hand and just holding the left side of reel, use the right thumb pressing gently on the film and roll forward. |
 |
5. Release the right hand and just holding the right side of reel, press gently with the left hand, roll backward with the right hand. |
 |
6. Repeat Step 4 and 5 until the whole roll of film is fit into the reel with a few cm. length left out. |
 |
7. Fit the reel into the center pole till base. If two reels are used, then the second one will fill up the center pole. |
 |
8. Put the center pole and reel into the tank. Be sure that the reel is at the bottom. |
 |
9. Put the PVC lid before inverted agitation. Though this allows rotate agitation, we do not suggested because this will cause a stream line effect since the developer is a suspension allowing most chemicals to gather at the bottom. |
|
|
